Oh, please don't think I was being critical. I know you do a very difficult job and a very GOOD JOB!!
I just didn't understand why the endurance and center of surgery are left in place. Personally I have a very wide definition of spam. If it doesn't contribute to the subject matter of the forum, it's spam, whether there's a link or whether the link goes anywhere, or not. microUgly has a very narrow definition of spam. If there's no link, it's not spam. And a little advertising is ok, if it can remotely be considered related to anything that Inkscape can do. I understand that you probably want to follow micro's definition.
To me, it's the repetition of endurance and surgery, that starts to be annoying.
Video tutorials how to make your own diy laser engraving / cutting machine.
Re: Video tutorials how to make your own diy laser engraving / cutting machine.
I know this is a lot of work, Lazur, and I can't even help, other than trying to get some attention for the problem with the unreachable forum owner, which I will :/
Something doesn't work? - Keeping an eye on the status bar can save you a lot of time!
Inkscape FAQ - Learning Resources - Website with tutorials (German and English)
Inkscape FAQ - Learning Resources - Website with tutorials (German and English)
Re: Video tutorials how to make your own diy laser engraving / cutting machine.
Moini, honestly, I don't think it's going to help, even if you can contact him. Look for another PM.
Basics - Help menu > Tutorials
Manual - Inkscape: Guide to a Vector Drawing Program
Inkscape Community - Inkscape FAQ - Gallery
Inkscape for Cutting Design
Manual - Inkscape: Guide to a Vector Drawing Program
Inkscape Community - Inkscape FAQ - Gallery
Inkscape for Cutting Design