This is a read-only archive of the inkscapeforum.com site. You can search for info here or post new questions and comments at I made a drawing in inkscape and I want to save it as an dxf file for lasercutting.
I've been going over a lot of tutorials I followed so I;
- I've checked the lines in image / contour mode and it looks perfectly clean.
- I placed everything in one layer
- Document properties in mm
- I've set object to path
I can open my dxf in lasercut but it has a lot of extra lines in it ??
I have an error message telling me that I'm losing a lot of information when saving to dxf is that normal ?
I've uploaded two files.
Thx so much for helping me out
Hella
